Thenologie FASSTest. Suport flybarless. Programare S.Bus.Telemetrie.
Radiocomanda 14SG are tot ce iti doresti...si chiar mai mult de atat!
Futaba ne prezinta modelul 14SG, singurul sistem cu 14 canale cu tehnologia revolutionara FASSTest 2.4 Ghz. Este compatibila cu protocoalele Futaba FASST si S-FHSS, deci practic poti zbura cu orice receiver 2.4 Ghz Futaba.
14SG poate transmite si receptiona date de telemetrie. Instaleaza senzorii Futaba de telemtrie (se vand separat) pentru a putea sa monitorizezi date de zbor, pentru a primi alerte in timpul zborului si multe altele. Pilotii de elicoptere vor adora sistemul de giro-suport pe 3 axe al modelului 14SG-lucru care il face sistemul pefect pentru zbor flybarless.
Inovatiile nu se opresc aici,. Daca te vei uita pe spatele radiocomenzii, vei vedea constructia solida a lui 14SG similara cu a altor sisteme Futaba. Datorita protectiilor de cauciuc, este foarte confortabil de folosit micsorand astfel oboseala din timpul zborului-un bonus pentru pilotii pasionati de zboruri lungi.
14SG are atat de multe de oferit incat nu putem sa acoperim totul aici. Pentru a vedea tot ce poate oferi, continua sa citesti...
system features
- Channels: 12 proportional, 2 switched
- Compatible with FASSTest, FASST and S-FHSS protocols
- FASSTest telemetry – compatible with Futaba telemetry sensors (sold separately)
- Free user-updatable software
- 30-model memory
- 10-character user naming
- 10-character model naming
- Airplane, helicopter and glider programming
- Large, 1.75†x 3†backlit LCD screen with 128 x 64 resolution
- SensorTouchâ„¢ programming
- Compatible with secure digital memory cards for external storage of model setups and software updates (32MB-2GB or HC (High-Capacity) 4GB-32GB)
- Left and right assignable slider switches
- Two assignable rotary knobs
- Six assignable three-position switches
- One assignable momentary two-position switch
- One assignable two-position switch
- Comfortable rubber grips on the sides and back
- Wide top switch spacing
- Adjustable stick tension
- Dual ball bearing gimbals
- 4 vibration warning types
- Home/Exit; User Menu/Servo Monitor buttons
- Audio earphone jack (for telemetry alarms)
- 6V 1800mAh NiMH battery pack
- User stick calibration
- Trainer system
- Servo speed adjust
- 5 programmable mixes
- V-tail, Ailvator, winglet, motor mixing
- Trim mix
- Logic switch (condition switch only)
- Internal programmer for S.Bus servos
- User menu
- Servo monitor (neutral and moving tests)
- 2 count up/countdown timers
- Integral timer
- Model timer
- Quick model select
menu Aircraft
- 7 different wing types
- 3 different tail types
- 2 different rudder types
- Flap setting menu
- Differential ailerons
- Aileron to camber flap mixing
- Aileron to brake flap mixing
- Aileron to rudder mixing
- Rudder to aileron mixing
- Rudder to elevator mixing
- Camber mixing
- Elevator to camber mixing
- Camber flap to elevator mixing
- Snap roll mixing
- Airbrake mixing
- V-Tail mixing
- Ailvator
- Winglet
- Motor mixing
- Fuel mixture mixing
- Gyro mixing
- Throttle curve (5-point)
- Pitch curve (5-point)
- Idle down
menu Heli
- 6 swash plate types
- Pitch/throttle curves (5-point)
- Throttle hold
- Swash mix
- Throttle mix
- Pitch to rudder mixing
- Fuel mixture
- Gyro (Flybarless support)
- Governor (700-3500 rpm)
- Hover pitch
- Hover throttle
- High/low pitch
- Swash AFR
- Swash setting (mixing rate, linkage compensation, speed compensation)
- Swash ring (electronic)
- Throttle cut
menu planor
- 11 different wing types
- 3 different tail types
- 2 different rudder types
- Flap setting menu
- Differential ailerons
- Aileron to camber flap mixing
- Aileron to brake flap mixing
- Aileron to rudder mixing
- Rudder to aileron mixing
- Rudder to elevator mixing
- Camber mixing
- Elevator to camber mixing
- Camber flap to elevator mixing
- Butterfly mixing
- Butterfly to elevator mixing
